Download Model Supported A3 06+ 1, 2 Symphony I, II Radio A4 98-06 A6 98-04 A8 98-01 S4 98-05 S6/R6 98-04 S8 98-01 Allroad 00-05 i-Audi-R TT 00-06 i-Audi-R 1, 2 1 1 1 1 1 1 1 Symphony I, II Radio Symphony I, II Radio Symphony I, II Radio Symphony I, II Radio Symphony I, II Radio Symphony I, II Radio Symphony I, II Radio Chorus and Concert Radios i-Audi-R i-Audi-R i-Audi-R i-Audi-R i-Audi-R i-Audi-R i-Audi-R. Installation Instructions 1. Pull vehicle into service bay and access trunk area. 2. Disconnect both battery terminals. These cables must be disconnected during installation to insure proper initialization of the DICE module when the DICE when it is connected. 3. Remove radio by inserting the (4) factory keys (not included) into the slots on each corner of the radio. Radio removal keys (not included) 4. CD changer interface will be on left hand side of radio, it is the smaller left-hand connector on the bottom of the harnesses. Remove all wiring from the radio unit and remove from vehicle. 5. Shown is the CD Changer harness through the back of the radio. The vehicle specific cable will be interfacing from this point. 3 6. Insert the vehicle specific cable into the specified connector. Make sure the connector is fully inserted and that it snaps in place. 7. Connect the vehicle specific cable’s 8-pin molex and iPod Docking Cable to the DICE module. The correct plugs on the DICE module can be identified by matching it up with the connector or by looking for the label on the bottom of the module. connector 8. Connect the remaining adapters and antenna leads back into the radio and prepare for re-installation. Verify all leads are firmly locked into place. Its recommended to install your DICE module in a easily accessable location or to extend theAUX connector for future connections of auxiliary devices. 1/8″ AUX Dock Cable Vehicle Specific Cable
The post i-R DICE iPod Integration Kit for Audi Radio Interface Kit appeared first on ToManual.com.
